AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Usb network gate linux11/6/2022 ![]() ![]() The approach allows devices with very limited communications hardware to operate over IP networks. The Bahia Network Driver is a usbnet-style driver available for Win32 hosts. On Linux hosts, the corresponding Ethernet-over-USB kernel module is called usbnet. Any applications that work over real Ethernet interfaces will work over a USB-eth interface without modification, because they can't tell that they aren't using real Ethernet hardware. It creates a Linux network interface, which can be assigned an IP address and otherwise treated the same as a true Ethernet interface. The USB-eth module in Linux makes the computer running it a variation of an Ethernet device that uses USB as the physical medium. See link below for careful protocol comparisons. The NCM protocol has elaborate provisions for this. Since the new devices, although faster than before, are still much lower in power than desktop PCs, the issue of careful data handling arises, to maximize use of DMA resources on the device and minimize (or eliminate) copying of data (zero-copy). A gap every 23 frames is not noticeable, but a gap every three frames can be very costly to throughput.Īs USB has become faster, devices have also become hungrier for data and so there is now demand for sending large amounts of data-either to be stored on the device, or be relayed over wireless links (see 3GPP Long Term Evolution). This reduces bus occupancy, meaning that nothing is sent for considerable fractions of bus time. After this, there is bus latency, where nothing is sent until another transfer can be initiated. According how the USB system works, each packet is sent as a transfer, a series of maximum-length packets terminated by a short packet or a special ZLP (zero-length packet). ![]() The problem is that Ethernet frames are about 1500 bytes in size-about 3 USB 2.0 packets, and 23 USB 1.1 packets. ![]() This was a good strategy for USB 1.1 systems (current when the protocol was issued) with 64 byte packets but not for USB 2.0 systems which use 512 byte packets. Of these protocols ECM is by far the simplest-frames are simply sent and received without modification one at a time. ![]() Remarkably, even some of the most modern platforms need minor accommodations and therefore support for these subsets is still needed. However, minor modifications of the standard, so-called subsets, make practical implementations possible on such platforms. Regarding de facto standards, some standards, such as ECM, specify use of USB resources that early systems did not have. The RNDIS specification is available from Microsoft's web site. They are available for download from the USB-IF (see below). The latter three are part of the larger Communications Device Class (CDC) group of protocols of the USB Implementers Forum (USB-IF). The main industry protocols are (in chronological order): Remote NDIS (RNDIS, a Microsoft vendor protocol), Ethernet Control Model (ECM), Ethernet Emulation Model (EEM), and Network Control Model (NCM). Even though USB is not a physical Ethernet, the networking stacks of all major operating systems are set up to transport IEEE 802.3 frames, without caring much what the underlying transport really is. The main motivation for these protocols is to allow application-independent exchange of data with USB devices, instead of specialized protocols such as video or MTP. There are numerous protocols for Ethernet-style networking over USB. ![]()
0 Comments
Read More
Leave a Reply. |